Ceramic Coating GYEON Q² Mohs EVO 100ml (8809432672555)

After two years of intensive research and development, it was time to take the Gyeon coating range to the next level. Thanks to technological advances within the polysilazane chemistry group, Gyeon has managed to almost double durability and significantly simplify the application process. The application and wipe-off window has been greatly extended thanks to the new formulas.

Moreover, all new EVO coatings no longer require a two-layer application — one layer is sufficient — and they can be applied outdoors; a garage is no longer mandatory. The key requirement is to keep the vehicle in a dry place for the next 12 hours and apply the product in the shade.

Q² Mohs EVO is Gyeon’s traditional silicone ceramic coating — essentially the original formula that made Gyeon known worldwide. It combines the benefits of modern silicone technology with extremely user-friendly application and use. With the new formula, the product remains easy to buff off for a full 5 minutes after application, making the coating process genuinely enjoyable.

Q² Mohs EVO is the only product that still allows you to build a thicker layer through multi-layer application to maximise durability. However, even a single layer of Q² Mohs EVO is enough for full protection: it provides chemical resistance across a pH range of 2 to 11 and ensures quick and easy vehicle cleaning.

Key Features

• pH range: 2–11
• Consumption: approx. 30 g per vehicle
• Durability (1 layer): up to 36 months (> 40,000 km)
• Durability (2 layers): up to 48 months (> 50,000 km)
• Keep the vehicle dry for 12 hours after application; apply in shade (as stated)

Kit Contents

• 1 pc GYEON Q² Mohs 100 мл
• 1 pc GYEON Q²M Cure 100 мл
• 1 pc GYEON Q²M Coating Applicator
• 1 pc GYEON user manual

Application Recommendations

1. Surface preparation quality drives gloss, durability and hydrophobic effect (as stated).
2. Wash/decontaminate with Q²M Foam, Q²M Tar, Q²M Iron, Q²M Clay.
3. Polish painted surfaces with Q²M Polish; use Q² Primer if required.
4. Wash with a strong degreaser, e.g., dishwashing liquid and hot water (as stated).
5. Remove wax and oily polishing residues using Q²M Prep (IPA alone is not sufficient, as stated).
6. Shake; apply a few drops onto the applicator.
7. Apply cross-hatch over small sections until the layer is even and wet.
8. After 10–30 seconds, wipe residue with a fresh Q²M BaldWipe towel to level the finish.
9. Optional: apply a second layer after at least 1 hour.
10. After 1 hour, apply Q²M Cure Spray and wipe with Q²M SoftWipe to help protect against potential water spots.

After Application

Avoid water contact for 24 hours and do not wash with shampoo for 14 days during polymerisation (as stated).