Two-layer quartz paint protection SOFT99 H-9 Dual Layer Glass Coat (10117)

SOFT99 H-9 Dual Layer Glass Coat combines two quartz products into one protective system. The Base Coat focuses on gloss and protection against mechanical impact, while the Top Coat focuses on hydrophobic behaviour.

Performance & Surface Effect

Delivers deeper, richer gloss and a more saturated look through the dual-layer construction.

Protection & Resistance

Stated durability is up to 2 years. Pencil Hardness 9H is stated as protection against micro-scratches that can occur with incorrect washing and drying. Strong hydrophobic behaviour helps reduce dirt build-up.

Key Features

• Dual-layer system: Base Coat (gloss + mechanical protection) and Top Coat (hydrophobic layer)
• Stated durability: up to 2 years
• Stated hardness: 9H (Pencil Hardness)
• Strong hydrophobic behaviour to reduce dirt adhesion

Kit Contents

• 1 × 100 мл Base Coat
• 1 × 100 мл Top Coat
• 2 × applicators
• 2 × microfibre towels
• 2 × gloves

Application Recommendations

1. Before starting, ensure the vehicle is washed, polished (no holograms), degreased, and the surface is neither hot nor cold. Prepare the workspace: no direct sunlight, minimal dust and dirt. Application temperature: from +15°C to +30°C.
2. Put on gloves and install the dispenser on the Base Coat bottle.
3. Prime the white side of the applicator with a small amount and apply using straight, overlapping passes. Work in sections of approximately 1 m²; avoid missed areas.
4. Buff the treated area immediately with the supplied microfibre towel—do not wait for it to dry. In summer this takes about 1 minute; in winter 2–5 minutes.
5. In cold or humid conditions, when the product dries more slowly than usual, apply Base Coat in two layers.
6. Wait 20–30 minutes after applying Base Coat.
7. Shake the Top Coat bottle thoroughly and install the dispenser.
8. Apply the second layer the same way as Base Coat, using a new applicator and a new microfibre towel.
9. Shake the bottle periodically and ensure there is no sediment at the bottom.
10. Leave the vehicle to fully dry in a clean, dry place (stated time: 12 hours), or use shortwave infrared drying.

Important Notes / Warnings

• Work section by section and buff promptly to avoid difficult wipe-off.